SECTION III: AIR INTAKE SYSTEM
TM 9-2350-256-20
4-26 REPLACE AIR INTAKE HOSES
THIS TASK COVERS
a. Removal
b. Installation
INITIAL SET-UP
Tools:
Equipment Conditions:
Tool kit, general mechanic's (Appendix C,
• Air cleaner removed (see paragraph 4-24)
item 53)
• Engine deck removed (see paragraph 9-51)
• APU access cover removed (see paragraph 9-49)
Parts:
• Left and center-front air inlet grilles removed (see
• Lockwashers (8) (Appendix G, item 132)
paragraph 9-57)
• Lockwashers (2) (Appendix G, item 134)
• Air inlet doors opened (see paragraph 9-56)
• Packing, preformed (Appendix G, item 189)
• Pins, cotter (3) (Appendix G, item 207)
a. REMOVAL
Both Sides
1
Remove three retaining rods (1) by removing cotter
pin (2) and straight pin (3) from each.
2
Remove two clamps (4) and air intake hose (5).
3
Remove two screws (6), two lockwashers (7), two
flat washers (8), and two nuts (9) from right and
left side of elbow assembly (10).
4
Disconnect air cleaner restriction indicator hose
(11) from air intake hose (5).
5
Remove preformed packing (12).
Left Side
6
Loosen two clamps (13) and remove air intake hose
(14).
4-55
