SECTION V:
VEHICLE WIRING
TM 9-2350-256-20
b.
DISASSEMBLY
Disassemble wiring harness (see Chapter 6, Section VII).
c.
ASSEMBLY
Assemble wiring harness (see Chapter 6, Section VII).
d.
INSTALLATION
1
Connect connectors (13 and 14) to switch panel, radio, and bilge pump to bulkhead wiring harness (28).
2
Connect connectors (11 and 12) to switch panel to neutral safety switch to bulkhead wiring harness (29).
3
Connect connectors (10) to switch panel, radio, and bilge pump to bulkhead wiring harness (28).
4
Connect connector (9) to bilge pump lead relay wiring harness (27).
5
Connect connectors (8) to winch illumination lamp assembly (26).
6
Install ground lead (7) to hull (23) using new lockwasher (25) and screw (24).
7
Connect connector (6) to troublelight assembly (22).
8
Connect connector (5) to rigger's fixed spotlight (21).
9
Connect connector (4) to ventilator blower (20).
10 Connect connectors (2 and 3) to two dome lights (19).
11 Connect connector (1) to electrical accessories panel
(18).
12 Install 20 clamps (15) each with new lockwasher (17)
and screw (16).
NOTE
Follow-on maintenance:
Install stowage basket
intermediate forward floor
plate (see paragraph 9-21)
6
105