SECTION V:VEHICLE WIRINGTM 9-2350-256-20b.DISASSEMBLYDisassemble wiring harness (see Chapter 6, Section VII).c.ASSEMBLYAssemble wiring harness (see Chapter 6, Section VII).d.INSTALLATION1Connect two connectors (11 and 12) to switch panel to gage panel and miscellaneous switches wiring harness (32).2Connect connectors (10) to power control switch (31).3Connect connector (9) to fuel tank transmitter (30).4Install ground lead (8) using bolt (29).5Connect connector (7) to mechanical transmission low oil pressure switch (28).6Install connector (6) and new gasket (27) to bulkhead disconnect (22) using three screws (25) and three newlockwashers (26).7Install ground lead (5) to bulkhead disconnect (22) using screw (23) and new lockwasher (24).8Connect connector (4) to powerpack warning hornassembly (21).9Connect connector (3) to powerpack warning horn (20).10 Connect connector (2) to APU control box to footdimmer switch and bulkhead wiring harness (19).11 Install connector (1) to gage panel bracket (16) usingfour new lockwashers (18) and four screws (17).12 Install 19 clamps (13) using new lockwasher (15) andscrew (14) for each.NOTEFollow-on maintenance:Install air cleaner (see paragraph 4-24)6—101
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business