CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6-60 REPLACE/REPAIR ENGINE DISCONNECT TO PRESSURE SWITCH WIRING HARNESS (12314651)-
Continued
a. REMOVAL
1
Remove five straps (6).
2
Disconnect two connectors (1 and 3) from two pressure switches (7).
3
Disconnect connector (2) from engine disconnect to starter wiring harness (8).
4
Disconnect two ground leads (4 and 5).
b. DISASSEMBLY
Disassemble wiring harness (see Chapter 6, Section VII).
c. ASSEMBLY
Assemble wiring harness (see Chapter 6, Section VII).
d. INSTALLATION
1
Connect two ground leads (4 and 5).
2
Connect connector (2) to engine disconnect to starter
wiring harness (8).
3
Connect two connectors (1 and 2) to two pressure
switches (7).
4
Install five new straps (6).
NOTE
Follow-on maintenance: Install powerplant (see
paragraph 3-1)
6-158
