SECTION V: VEHICLE WIRING
TM 9-2350-256-20
b. DISASSEMBLY
Disassemble wiring harness (see Chapter 6, Section VII).
c. ASSEMBLY
Assemble wiring harness (see Chapter 6, Section VII).
d. INSTALLATION
1
Install two connectors (3 and 4) to starter (13) using new lockwasher (15) and nut (14).
2
Connect connector (2) to fuel solenoid wiring harness (12).
3
Connect connector (1) to engine disconnect (8) using four nuts (11), four new lockwashers (10), and four
screws (9).
4
Install clamp (5) using new lockwasher (7) and screw (6).
NOTE
Follow-on maintenance: Install powerplant (see paragraph 3-1)
6-62 REPLACE/REPAIR ENGINE DISCONNECT TO ENGINE GENERATOR RELAY LEAD (SINGLE VOLTAGE)
(11671362)
THIS TASK COVERS
a.
Removal
b.
Disassembly
c.
Assembly
d.
Installation
INITIAL SET-UP
Tools:
Equipment Condition:
Tool kit, general mechanic's (Appendix C, item 53)
Engine deck removed (see paragraph 9-51)
WARNING
Be certain MASTER switch is OFF when working on electrical systems to avoid electrical
shock and burns.
Connector No.
Electrical Lead To:
Wire No.
1
Main engine generator relay
2
2
Engine disconnect
2
6-161
