SECTION V: VEHICLE WIRINGTM 9-2350-256-20b. DISASSEMBLYDisassemble wiring harness (see Chapter 6, Section VII).c. ASSEMBLYAssemble wiring harness (see Chapter 6, Section VII).d. INSTALLATION1 Connect ground lead (4) to solenoid bracket (7) using new locknut (9) and cap screw (8).2 Connect two connectors (2 and 3) and to two fuel solenoids (6).3 Connect connector (1) to exhaust smoke generating system lead assembly (5).NOTEFollow-on maintenance: Install engine deck (see paragraph 9-51)6-96 REPLACE/REPAIR FUEL/WATER SEPARATOR CONTROL MODULE TOSOLENOID DRAIN VALVE WIRING HARNESS (11684127)THIS TASK COVERSa. Removalb. Disassemblyc. Assemblyd. InstallationINITIAL SET-UPTools:Equipment Condition:Tool kit, general mechanic's (Appendix C, item 53)Engine deck removed (see paragraph 9-51)WARNINGBe certain MASTER switch is OFF when working on electrical systems to avoid electrical shock and burns.Connector No.Electrical Lead To:Wire No.1Solenoid drain valveGND2Fuel/water separator control moduleGND6-251
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business