CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITSTM 9-2350-256-206-96 REPLACE/REPAIR FUEL/WATER SEPARATOR CONTROL MODULE TOSOLENOID DRAIN VALVE WIRING HARNESS (11684127)--Continueda. REMOVAL1 Disconnect connector (1) from solenoid drain valve(3).2 Disconnect connector (2) from fuel/water separatorcontrol module (4).3 Remove clamp (5) by removing screw (6) andwasher (7).b. DISASSEMBLYDisassemble wiring harness (see Chapter 6, SectionVII).c. ASSEMBLYAssemble wiring harness (see Chapter 6, Section VII).d. INSTALLATION1 Install clamp (5) using washer (7) and screw (6).2 Connect connector (2) to fuel/water separatorcontrol module (4).3 Connect connector (1) to solenoid drain valve (3).NOTEFollow-on maintenance: Install engine deck (see paragraph 9-51)6-97 REPLACE/REPAIR EXHAUST SMOKE GENERATING SYSTEM LEADASSEMBLY (11672385)THIS TASK COVERSa. Removalb. Disassemblyc. Assemblyd. InstallationINITIAL SET-UPTools:Material:Equipment Condition:Tool kit, general mechanic'sWire, electrical (Appendix D,Engine deck removed (see(Appendix C, item 53)item 34)paragraph 9-51)WARNINGBe certain MASTER switch is OFF when working on electrical systems to avoid electrical shock and bums.Connector No.Electrical Lead To:Wire No.1Smoke generating system lead assembly (11672473-2)T2Bulkhead to main engine bracket and rear fuel tank transmitterTwiring harness at bulkhead disconnect6-252
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business