SECTION II: TRANSMISSION OIL COOLER LINES, BRACKET, SADDLETM 9-2350-256-20SEALS, AND OUTPUT REDUCTION DRIVES7-7 REPLACE TRANSMISSION OIL COOLER LINES AND SAMPLING VALVETHIS TASK COVERSa. Removalb. InstallationINITIAL SET-UPTools:Parts:Equipment Condition:Tool kit, general mechanic'sGaskets (4) (Appendix G,Engine deck removed (see(Appendix C, item 53)item 83)paragraph 9-51)a. REMOVALNOTEEngine exhaust pipes removed for clarity.1Remove two left-side oil cooler lines (1) from transmission by disconnecting two coupling nuts (2) at two tees (3), and two coupling nuts (4) and two reducers (5) on opposite ends of two oil cooler lines. Remove and discard two gaskets (6) from transmission oil cooler.2Remove two clamps (7) from around two right-side oil cooler lines (8) by removing screw (9), two flat washers (10), and nut (11) from each.3Remove two right-side oil cooler lines (8) by disconnecting two coupling nuts (12) at two tees (3), and two coupling nuts (13) and two reducers (14) on opposite ends of two oil cooler lines. Remove and discard two gaskets (15) from transmission oil cooler.4Disconnect temperature transmitter (16) and pressure transmitter (17) from crosspipe (18).5Remove two tees (3), crosspipe (18), and bushing (19).7-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business