TM 9-2350-256-34-2Figure 3-31. Disassembly of flow regulator subplate assembly.3-32.Repair of Flow Regulator Subplate Assembly Componentsa.General. Remove and replace defective component following sequence indicated in figure 3-31.b.Cleaning. Wash all parts in dry-cleaning solvent or mineral spirits paint thinner. Dry parts with moisture-freecompressed air; then immerse parts in clean OE-10 oil, to prevent rusting.c.Inspection.(1) Inspect all threaded parts for nicks, burs, and cross-threading. Repair with a thread chaser.(2) Inspect flow regulators for cracks or dented surface.(3) Inspect fittings for nicks, burs, cracks or leakage. Remove burs with a fine, hard, sharpening stone.3-33.Assembly of Flow Regulator Subplate AssemblyAssemble the flow regulator subplate assembly in reverse order of disassembly (fig. 3-31).3-47
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
