TM 9-2350-256-34
0040 00
Cleaning
1.
Wash hose in a mild detergent solution, rinse with clean water, and dry with compressed air.
WARNING
Solvents can burn easily, can give off harmful vapors, and are harmful to skin and clothing. To avoid
injury or death, keep away from open fire and use in a well-ventilated area. If solvent gets on skin or
clothing, wash immediately with soap and water.
2.
Clean all metal parts with cleaning compound or paint thinner. Use a wire brush where necessary and dry with compressed
air.
Inspection-Acceptance and Rejection Criteria
1.
Check that leading edge of each sleeve is at least 1/8 in. (3.2 mm) from end of tube and close to or touching tube.
2.
Check that back of each sleeve is in contact with tube.
3.
Inspect sleeves for evidence of wear and distortion.
4.
Inspect hose for fraying, cracks, or excessive wear.
Repair or Replacement
1.
Replace all defective parts. If either sleeve is defective, replace entire assembly.
0040 00-2
