TM 9--2350--292--10
0106 00--2
RELEASE TRACK TENSION (NEW CONFIGURATION) -- CONTINUED
0106 00
WARNING
Grease will be under pressure. Personnel must wear goggles. Failure to comply
may result in eye injury to personnel.
2. Press in and hold plunger (3) on grease relief valve (4) to allow grease to flow out of track adjusting link (2).
3. Catch grease with clean wiping rag.
4. Release plunger (3) when grease stops flowing out of track adjusting link (2).
5. Wipe up grease with wiping rags.
NOTE
If further compression of the track adjusting link is required, perform steps 5 through
10.
6. Remove two machine plugs (5).
7. Start engine (WP 0012 00).
8. To compress track adjusting link, turn vehicle to the rear in the direction opposite to the track adjusting link (2).
9. Shut down engine (WP 0019 00).
10. Install two machine plugs (5).
2
4
3
5
5
END OF TASK