TM 9--2350--292--10
0108 00--1
TRACK SHOE REPLACEMENT
0108 00
THIS WORK PACKAGE COVERS:
Repalcement
INITIAL SETUP:
Tools and Special Tools
Track binder (item 7, Table 2, WP 0128 00)
End connector puller and pump (item 28, Table 2, WP
0128 00)
Sledgehammer (item 32, Table 2, WP 0128 00)
Track connecting fixtures (item 14, Table 2, WP
0128 00)
Ratchet (item 38, Table 2, WP 0128 00)
Tankers bar (item 5, Table 2, WP 0128 00)
Personnel Required
Three
References
WP 0128 00
WP 0110 00
WP 0103 00
WP 0104 00
WP 0102 00
WP 0012 00
WP 0105 00
WP 0106 00
1. Position vehicle until shoe to be replaced is between idler wheel and front road wheel.
2. Open armor skirt plates #1, #3, #5 and #7 (WP 0102 00).
3. Install track binder (WP 0110 00).
4. Release track tension (WP 0105 00 or WP 0106 00).
WARNING
NOTE
Disconnect track between idler wheel and first roadwheel.
5. Remove two bolts (1) and two wedges (2) from two end connectors (3). After loosening bolt a few turns, rap bolt
with sledgehammer sharply to loosen wedge.
6. Hit end connector (3) with sledgehammer to loosen.
7. Place hook (5) of end connector puller (4) behind end connector (3).
8. Align two studs (6) with shoe pins (7).
9. Pump handle (8) until gap between end connector (3) and track shoes (9) is about 1 in. (2.5 cm).
1
9
4
6
8
3
2
7
5