TM 9--2350--292--20--10226 00--14ACCELERATOR CONTROLS AND LINKAGE REPAIR -- CONTINUED0226 00Installation--Continued31. Move shaft (94) left or right until pedal linkage and linkage to rear of shaft is parallel and will not binHold shaft (94)in position and tighten set screws (118) on two pillow blocks (112).WARNING32. Clean hole in bulkhead for linkage using rags and dry cleaning solvent.33. Install boot (59), bushing (61) and clamp (60) on rod (64).34. Install nut (63) and rod end (62) on rod assembly (32).35. Install rod assembly (32) through hole in bulkhead.36. Install screw (56) and new lockwasher (57) attaching rod assembly (32) to clevis (58).37. Apply a small amount of adhesive to groove in boot (59) and the hole in bulkhead.38. Install the boot (59) into bulkhead hole and allow to dry for five minutes.39. Install nut (55) and rod end (54) on rod assembly (32).Figure 3558575632545564596160636294118118112112
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business