TM 9--2350--292--20--1HEADLIGHT ASSEMBLY REPAIR -- CONTINUED0273 00AlignmentNOTEAlignment of lights should be performed in shaded ordimly lit areas. Aim with low beam only.1. Measure distance from center of sealed lamp unit (service side, clear) to ground. Duplicate this measurement onwall, drawing a horizontal centerline (56) of lamp unit.2. Draw a line (57) parallel to and 27--1/4 inches (69.2 cm) below, line.3. Turn lights on low beam. Center of right and left beam should be on lower line (57). Adjust, if necessary.AdjustmentNOTEPerform steps 1 through 3 if performing headlight adjust-ment when headlight has been replaced or headlight isout of adjustment.Perform steps 2 and 3 if performing headlight adjustmentwhen headlight has been disassembled/assembled.Mounting base must be parallel to horizontal plane in or-der to achieve accurate headlight adjustment.1. Loosen three screws (53).2. Manually adjust headlight assembly up or down until center of low beam is on lower line (57).3. Tighten three screws (53).Figure 8325’27--1/4’’(69.2CM)565753END OF TASK0273 00--9/10 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
