TM 9--2350--292--20--1
0277 00--1
EMERGENCY FLASHER LAMP ASSEMBLY REPAIR
0277 00
THIS WORK PACKAGE COVERS:
Removal, Disassembly, Assembly, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Materials/Parts
Lockwasher (item 339, WP 0718 00)
Finishing washer (item 340, WP 0718 00)
Retaining rings (2) (item 341, WP 0718 00)
Electrical contact (item 342, WP 0718 00)
Electrical connector (item 343, WP 0718 00)
Nonmetallic grommet (item 344, WP 0718 00)
Marker tags (item 49, WP 0716 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Battery power disconnected (WP 0256 00)
References
TM 9--2350--292--10
NOTE
Perform Disassembly steps 1 through 5 and 7 and As-
sembly steps 2 through 6 for replacement of headlight
only.
Tag all electrical connections and electrical leads prior to
removal to aid in installation.
Removal
1. Disconnect wiring harness 4W101 wire 325A (1) from electrical connector (2) on rear of lamp assembly (3).
2. Remove nut (4), lockwasher (5), finishing washer (6) and lamp assembly (3) from vehicle. Discard lockwasher
and finishing washer.
Disassembly
1. Loosen three screws (7), remove lens retainer (8) from light housing (9).
2. Remove three retaining clips (10) securing headlight (11) in lens retainer (8).
Figure 87
3
8
7
11
10
10
10
2
9
6
5
4
1
