TM 9--2350--292--20--1
0279 00--3
REAR SERVICE LIGHT REPAIR -- CONTINUED
0279 00
Assembly
1. Push ground lead of connector assembly (22) through hole in bottom of body (13) and connect to mount (27) with
screw (28) and new lockwasher (29).
2. Install four screws (26) securing mount (27) to body (13).
3. Push two leads of connector assembly (22) through holes in rear of body (13), install two new preformed packings
(25) and connect leads to connector plate assembly (24).
4. Install connector plate assembly (24) on body (13) with two screws (23).
5. Install lamp (21) in connector assembly (22).
6. Install plate assembly (20) on body (13), tighten three captive screws (19).
7. Install new gasket (17), lens (16) and plate assembly (15) on door assembly (18), tighten four captive screws (14).
8. Install lens assembly (11) and new preformed packing (12) on body (13), tighten four captive screws (10).
Figure 89
11
18
10
17
16
15
14
12
13
19
20
21
22
28
29
27
26
25
25
24
23
