TM 9--2350--292--20--10041 00--6ENGINE FAILS TO CRANK WHEN STARTER SWTICH IS PRESSED --CONTINUED0041 00CONTINUED FROM STEP MIs 24 V dc present?1. Disconnect lead 14 from panel side of neutralsafety switch.2. Turn MASTER switch ON and hold STARTswitch in the ON position(TM 9--2350--292--10).3. Place multimeter red lead in lead 14 neutralsafety switch connector socket and black leadto ground. Check for voltage.4. Turn MASTER switch OFF(TM 9--2350--292--10).NnoyesRepair (WP 0290 00) orreplace (WP 0315 00)lead 14 to neutral safetyswitch. Verify fault iscorrected.Is 24 V dc present?noyesO 1. Turn MASTER switch OFF(TM 9--2350--292--10).2. Reconnect lead 14 to panel side of neutralsafety switch.3. Disconnect lead 14 from bulkhead side ofneutral safety switch.4. Turn MASTER switch ON and hold STARTswitch in the ON position (TM 9--2350--292--10).5. Place multimeter red lead in neutral safetyswitch connector socket and black lead toground. Check for voltage.6. Turn MASTER switch OFF(TM 9--2350--292--10).Replace neutral safetyswitch (WP 0252 00) .Verify fault is corrected.CONTINUED ON NEXT PAGE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business