TM 9--2350--292--20--10101 00--1HOIST WINCH CREEPS WITH CONTROL IN NEUTRAL.0101 00THIS WORK PACKAGE COVERS:Hoist Winch Creeps With Control In NeutralINITIAL SETUP:Tools and Special ToolsGeneral mechanic’s tool kit (item 1, WP 0717 00)0--300 psi dial pressure gauge (item 81, WP 0717 00)*0--4000 psi testing gauge assembly (2)(item 82, WP 0717 00)*0--5000 psi dial pressure gauge (2)(item 83, WP 0717 00)*1/4--inch tee (2) (item 71, WP 0716 00)*Safety goggles (item 93, WP 0716 00)Equipment ConditionsVehicle MASTER switch OFF (TM 9--2350--292--10)Subfloor plates 10, 15, 18 and 22 removed(WP 0454 00)Personnel RequiredTwo*Not required if vehicle is equipped with EnhancedDiagnostic System.noyesAGo to Step D.WARNINGWARNINGRemove rings, bracelets, wristwatches, andneck chains before working on any vehicle.Jewelry can catch on equipment and causeinjury, or may short across an electrical circuitand cause severe burns or electrical shock.1. Install 0--4000 psi testing gauge assembly with1/4--inchtee between hoist and main winch directional controlvalve assembly port PHR and attaching hose.2. Install 0--4000 psi testing gauge assembly with1/4--inch tee between hoist and main winch directionalcontrol valve assembly port PHL and attaching hose.3. Start main engine, energize hydraulics, and set enginespeed to 1800 rpm (TM 9--2350--292--10). Observegauges.BIs vehicle equipped with Enhanced DiagnosticSystem?WARNINGCONTINUED ON NEXT PAGEFORWARD
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
