HOIST WINCH BRAKE FAILS TO HOLD A LOAD (cont)

HOIST WINCH CREEPS WITH CONTROL IN NEUTRAL (cont) - TM-9-2350-292-20-1_518

HOIST WINCH BRAKE FAILS TO HOLD A LOAD (cont) - TM-9-2350-292-20-1_520

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
475

TM 9--2350--292--20--1 0102 00--1 HOIST WINCH BRAKE FAILS TO HOLD A LOAD. 0102 00 THIS WORK PACKAGE COVERS: Hoist Winch Fails To Hold A Load INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) 0--5000 psi dial pressure gauge (item 83, WP 0717 00)* 0--4000 psi testing gauge assembly (2) (item 82, WP 0717 00)* 1/4--inch tee (2) (item 71, WP 0716 00)* Safety goggles (item 93, 0716 00) Equipment Conditions Vehicle MASTER switch OFF (TM 9--2350--292--10) Subfloor plates 10, 15, 18 and 22 removed (WP 0454 00) Personnel Required Two *Not required if vehicle is equipped with Enhanced Diagnostic System. WARNING WARNING Remove rings, bracelets, wristwatches, and neck chains before working on any vehicle. Jewelry can catch on equipment and cause injury, or may short across an electrical circuit and cause severe burns or electrical shock. no yes A Go to Step D. Is vehicle equipped with Enhanced Diagnostic System? Is gauge pressure reading less than 460 psi? 1. Install 0--5000 psi dial pressure gauge in hoist winch motor test port. 2. Start main engine, energize hydraulics, and set engine speed to 1800 rpm (TM 9--2350--292--10). Observe gauge. 3. Shut down hydraulics and main engine (TM 9--2350--292--10). no yes B Notify Direct Support Maintenance. WARNING CONTINUED ON NEXT PAGE FORWARD

Privacy Statement
Press Release
Contact