TM 9--2350--292--20--1
SPADE CREEPS WITH SPADE CONTROL HANDLE IN HOLD.
0104 00
THIS WORK PACKAGE COVERS:
Spade Creeps With Spade Control Handle In Hold
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Personnel Required
Two
Does spade continue to creep?
1. Start main engine, energize hydraulics system
and set engine speed to 1800 rpm
(TM 9--2350--292--10).
2. Fully extend and retract spade five times.
3. Position spade in the mid--range position.
4. Shut down hydraulics and main engine
(TM 9--2350--292--10).
no
yes
A
B 1. Remove vehicle nose piece (WP 0497 00).
2. Inspect spade cylinders, isolator valve,
directional control valve, spade release cylinder,
check valve, and all connecting hoses for leaks,
restrictions, and damage.
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Fault corrected.
yes
no
Remove restrictions and
tighten leaking connec-
tions. If restrictions can-
not be removed or if com-
ponents are damaged,
replace (WP 0544 00
through WP 0585 00).
Verify fault is corrected.
Notify Direct Support
Maintenance.
Are all components and hoses free of leaks, restrictions,
and damage?
FORWARD
END OF TASK
0104 00--1/2 blank
