SPADE FAILS TO OPERATE

HOIST WINCH BRAKE FAILS TO HOLD A LOAD (cont) - TM-9-2350-292-20-1_521

SPADE CREEPS WITH SPADE CONTROL HANDLE IN HOLD

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
478

TM 9--2350--292--20--1 SPADE FAILS TO OPERATE. 0103 00 THIS WORK PACKAGE COVERS: Spade Fails To Operate INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) Equipment Conditions Vehicle MASTER switch OFF (TM 9--2350--292--10) Personnel Required Two Is quick--disconnect connected properly? Remove subfloor plate 7 (WP 0454 00) and in- spect spade hose quick--disconnects for proper connection. no yes A B Are all components and hoses free of leaks, restric- tions, and damage? WARNING Remove rings, bracelets, wristwatches, and neck chains before working on any vehicle. Jewelry can catch on equip- ment and cause injury, or may short across an electrical circuit and cause severe burns or electrical shock. Properly connect quick--disconnect. Verify fault is corrected. 1. Remove vehicle nose piece (WP 0497 00). 2. Check spade flow control valve, relief valve, spade release cylinder, spade cylinders, check valve, isolator valve, and all attached hoses for leaks, restrictions, and damage. yes no Tighten leaking connec- tions and remove restric- tions. If restrictions cannot be removed or if there is damage, replace (WP 0544 00 through WP 0585 00). Verify fault is corrected. Notify Direct Support Maintenance. FORWARD END OF TASK 0103 00--1/2 blank

Privacy Statement
Press Release
Contact