TM 9--2350--292--20--1
0130 00--1
ENGINE OIL TEMPERATAURE GAUGE FAILS TO OPERATE PROPERLY.
0130 00
THIS WORK PACKAGE COVERS:
Engine Oil Temperature Gauge Fails To Operate Properly
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Engine deck removed (WP 0417 00)
Gauge panel removed from bracket (WP 0243 00)
Personnel Required
Two
Is 24 V dc present?
1. Disconnect lead 27 from oil temperature
gauge.
2. Turn MASTER switch ON
(TM 9--2350--292--10).
3. Place multimeter red lead in lead 27 oil
temperature gauge connector socket and
black lead to ground. Check for voltage.
4. Turn MASTER switch OFF
(TM 9--2350--292--10).
no
yes
A
CONTINUED ON NEXT PAGE
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Repair (WP 0290 00) or re-
place (WP 0243 00) lead
27. Verify fault is corrected.
B
Does gauge read full scale with ground lead on and no
movement with ground lead off?
no
yes
1. Reconnect lead 27 to gauge.
2. Disconnect lead 33 from oil temperature gauge.
3. Place a ground lead in gauge connector and
run to vehicle ground.
4. Turn MASTER switch ON and then OFF
(TM 9--2350--292--10) watching gauge.
5. Remove ground lead and turn MASTER switch
ON then OFF (TM 9--2350--292--10) watching
gauge.
Replace gauge (WP 0243 00).
Verify fault is corrected.
