TM 9--2350--292--20--1
0130 00--4
ENGINE OIL TEMPERATURE GAUGE FAILS TO OPERATE PROPERLY --
CONTINUED
0130 00
F
Is 24 V dc present?
CONTINUED FROM STEP E
no
yes
CONTINUED ON NEXT PAGE
1. Reconnect lead 33 to gauge.
2. Reconnect harness 4W103 P1 to gauge panel.
3. Disconnect harness 3W143 P2 from bulkhead
disconnect.
4. Turn MASTER switch ON
(TM 9--2350--292--10).
5. Place multimeter red lead in bulkhead
connector J2 socket K and black lead to
ground. Check for voltage.
6. Turn MASTER switch OFF
(TM 9--2350--292--10).
Repair (WP 0290 00) or
replace (WP 0316 00)
harness 4W103. Verify
fault is corrected.
G
Is 24 V dc present?
no
yes
1. Reconnect harness 3W143 P2 to bulkhead
disconnect.
2. Disconnect harness 3W143 P1 from engine
disconnect.
3. Turn MASTER switch ON
(TM 9--2350--292--10).
4. Place multimeter red lead in harness 3W143
P1 socket K and black lead to ground. Check
for voltage.
5. Turn MASTER switch OFF
(TM 9--2350--292--10).
Repair (WP 0290 00) or
replace (WP 0295 00)
harness 3W143. Verify
fault is corrected.
