TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY (cont)

TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY (cont) - TM-9-2350-292-20-1_912

TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY (cont) - TM-9-2350-292-20-1_914

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
868

TM 9--2350--292--20--1 0187 00--87 0187 00 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS -- CONTINUED TABLE 3 PREVENTIVE MAINTENANCE CHECKS AND SERVICES INCLUDING LUBRICATION INSTRUCTIONS, SEMIANNUALLY -- CONTINUED ITEM NO. NOT FULLY MISSION CAPABLE IF: PROCEDURE LOCATION ITEM TO CHECK/ SERVICE INTERVAL SEMIANNUALLY INTERIOR 9 Acceleration and Pulling Power Test Test for normal acceleration and pulling power in each transmission range. a. While testing in low range, accelerate with wide--open throttle from low to top speed. Governed speed under load should reach 1875 rpm, but not exceed 2660 rpm. b. Listen for unusual noises that might indicate loose, damaged, excessively worn parts or loose mountings. If governed speed does not reach 1875 rpm or exceeds 2660 rpm. Any unusual noises. 10 Initial Road Test Take vehicle on a short road test, approximately 5 miles (8 km) and perform tasks 12 and 13. 11 Steering a. Move steering wheel through its entire range and observe if steering response is satisfactory. b. With vehicle operating at moderate speed and steering control centered, check for any tendency to wander or pull to one side. If either of these conditions exist, check steering controls and linkage adjustment (Chapter 13) Any binding or excessive looseness is detected.

Privacy Statement
Press Release
Contact