TM 9--2350--292--20--20667 00--43DEEP WATER FORDING KIT -- CONTINUED0667 00Removal--ContinuedMAIN ENGINE AIR INLETSNOTEThere are two air cleaner air inlet covers. Removal pro-cedures are the same for both.Install guide in hole pattern that places guide closest tohull. If stayline cable does not fit between the guide andthe hull, it is acceptable to use the other hole pattern.1. Remove four screws (19), four lockwashers (20), plate (18) and air inlet pipe (17). Remove elbow (16) from leftair inlet pipe. Discard lockwashers.2. Remove and discard inlet seal (15) from air inlet pipe (17). Clean adhesive from air inlet pipe (17).3. Install air inlet screen (14) on top of hull.4. Position air inlet cover (13) over air inlet screen (14) on top of hull.5. Position plate (12) and hood (11) on top of air inlet cover (13).6. Secure hood (11) and plate (12) to top of air inlet cover with two screws (8), two new lockwashers (9) and two flatwashers (10).7. Install screen (7), and plate (3) with two screws (1) and two new lockwashers (2).8. Install guide (6) with two screws (4) and two new lockwashers (5).9. Apply a bead of adhesive sealant (MIL--A--46106) between mating surfaces of hood (11) and appliqué armor,hood (11) and vehicle hull, hood (11) and plate (12), and between mating surfaces of plate (12) and vehicle hull.Figure 3541232019115689107121341714151816
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
