TM 9--2350--292--20--2
0668 00--1
BILGE PUMP BRACKET AND INLET FLANGE REPLACEMENT
0668 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Materials/Parts
Lockwashers (3) (item 174, WP 0718 00)
Lockwashers (4) (item 417, WP 0718 00)
Equipment Conditions
Bilge pump assembly removed from deep water
fording kit (WP 0667 00)
Removal
1. Remove four screws (1), four lockwashers (2), inlet flange (3) and impeller housing (4) from front end bell (5).
Discard lockwashers. After inlet flange (3) is removed, reinstall impeller housing (4) to front end bell (5) with four
screws (1) and four new lockwashers (2).
NOTE
Do not remove three studs and three nuts securing rear
end bell to stator housing for maintenance of bracket.
2. Remove three nuts (6), three lockwashers (7) and bracket (8) from three studs (9). Discard lockwashers.
3. Inspect parts for damage and replace as required.
Figure 357
5
4
3
1
2
9
6
7
8
