TM 9--2350--292--20--2
0429 00--2
LEFT STOWAGE DOOR ASSEMBLY REPAIR -- CONTINUED
0429 00
Disassembly
1. Remove cotter pin (5), nut (6), flat washer (7) if present, latch (8), spring washer (9) and handle (10) from stowage
door assembly (1). Discard cotter pin and spring washer.
2. Remove two self--locking nuts (11) and two screws (12), separate armor plate (13) from stowage door assembly
(1). Discard self--locking nuts.
3. Remove seal (14) from stowage door (15). Discard seal.
4. Inspect parts for damage and replace as required.
Assembly
WARNING
1. Clean seal mating surface on stowage door (15) with dry--cleaning solvent.
2. Apply rubber based adhesive to new seal (14) and seal mating surface on stowage door (15).
3. Install new seal (14) on stowage door (15).
4. Install armor plate (13) on stowage door assembly (1) with two screws (12) and two new self--locking nuts (11).
5. Install handle (10) and latch (8) on stowage door assembly (1) with new spring washer (9), nut (6) and new cotter
pin (5). Flat washer (7) is only required if cotter pin (5) does not engage the slots in nut (6) when handle parts are
assembled.
Figure 207
6
5
7
8
9
11
1
14
15
13
10
12