TM 9--2350--292--20--20439 00--2AUXILIARY POWER UNIT DOOR, FAN ASSEMBLY AND HOLD--OPEN LATCHREPLACEMENT (HATZ) -- CONTINUED0439 00Removal1. Disconnect APU door fan connector (1) from wiring harness 3W730 connector P3 (2).NOTEIdentify and note the location of clips, mounting blocksand plates prior to removal to aid in the Installation Theplates 8 and 9 should be identified to their top/bottomlocation on the APU door assembly.During replacement of fan, do not remove mountingplates (8 and 9) unless damaged.2. Remove four screws (3), four lockwashers (4), four flat washers (5) and four clips (6) from fan (7) and two mount-ing plates (8 and 9). Discard lockwashers.3. Remove four screws (10), four lockwashers (11), four flat washers (12) and fan (7) from two plates (8 and 9). Dis-card lockwashers.4. Remove eight screws (13), eight lockwashers (14), eight flat washers (15), eight mounting blocks (16) and twoplates (8 and 9) from door (17). Discard lockwashers.5. Inspect parts for damage and replace as required.1616345671112101314158915131412111217
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business