TM 9--2350--292--20--2
0354 00--1
OUTPUT REDUCTION UNIT (OUTPUT DRIVE) REPLACEMENT
0354 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Suitable lifting device (2,000 lbs (908 kg) min cap)
Suitable container(20.0 gal. (75.8 L) min cap)
Final drive sling (item 37, WP 0717 00)
Lifting sling (item 25, WP 0717 00)
Final drive sling adapter plate (item 78, WP 0717 00)
Torque wrench (item 9, WP 0717 00)
Torque wrench (item 2, WP 0717 00)
Screws (2) (item 110, WP 0717 00)
Materials/Parts
Lockwashers (12) (item 52, WP 0718 00)
Gaskets (2) (item 238, WP 0718 00)
Cotter pins (2) (item 17, WP 0718 00)
Cotter pin (item 239, WP 0718 00)
Lockwashers (12) (item 240, WP 0178 00)
Dry--cleaning solvent (item 1, WP 0716 00)
Pressure sensitive tape (item 41, WP 0716 00)
Materials/Parts--Continued
Self--locking screws (19) (item 241, WP 0718 00)
Preformed packings (4) (item 230, WP 0718 00)
Sealing compound (item 42, WP 0716 00)
Hardwood lumber (item 4, WP 0716 00)
Adhesive (item 25, WP 0716 00)
Equipment Conditions
Steering control linkage disconnected
(WP 0404 00)
Shifting control linkage disconnected
(WP 0407 00)
Final drive hub and sprocket removed on
defective drive (WP 0397 00)
Engine deck assembly removed (WP 0417 00)
Personnel Required
Two
NOTE
The following procedures are applicable to either the left
or right output drive; however, when either is being re-
moved, the other must also be partially dismantled to per-
mit raising the powerpack during the removal process.
Removal
1. Remove six screws (1), six lockwashers (2), gasket (3) and cover (4) at each of two hull drains. Discard lock-
washers and gaskets.
Figure 213
Figure 213
1
2
3
4
BOTTOM VIEW OF VEHICLE
FORWARD
