TM 9--2350--292--20--20354 00--4OUTPUT REDUCTION UNIT (OUTPUT DRIVE) REPLACEMENT --CONTINUED0354 00Removal--Continued7. Attach lifting sling (item 25, WP 0717 00) to two lifting brackets (20) above transmission output housings (18).Attach lifting sling to suitable lifting device.2018CAUTIONIf removing right output drive, ensure powerpack is raisedhigh enough above drive saddle to permit alignment halfring in lower drive saddle to clear transmission housing.8. With suitable lifting device, raise rear of powerpack until transmission output housing on each side is clear of therespective drive saddle. Several inches should be sufficient. Position hardwood blocks(4 x 4 x 6) under transmission. Lower powerpack until transmission rests on hardwood blocks. Remove slingfrom suitable lifting device.NOTEPerform the following procedures on the output drive be-ing replaced.WARNINGWARNINGTo keep output drive balanced as it is being removedfrom the vehicle, ensure sling assembly bracket is asclose as possible to open end of sling. Be careful whenlifting output drive to ensure output drive clears the hull.To avoid failure of sling or suitable lifting device, do notforce suitable lifting device to pull against weight of ve-hicle. Failure to comply may cause damage to equipmentor injury to personnel.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
