TM 9--2350--292--20--20354 00--8OUTPUT REDUCTION UNIT (OUTPUT DRIVE) REPLACEMENT --CONTINUED0354 00InstallationWARNING1. Clean screws (22) and mating surfaces of output reduction drive (19) and vehicle hull with dry--cleaning solvent.CAUTIONDo not apply pressure sensitive tape when ambient tem-perature is below 45°F (7.2° C). Failure to comply maycause loss of screw torque and equipment damage.2. Apply sealing compound to threads and under heads of screws (22). Apply sealing compound or pressure sensi-tive tape to surfaces of output reduction drives and vehicle hull.3. Install four new preformed packings (large O--rings) (30) in inner and middle grooves of both left and right sidetransmission output housings (18).Figure 1641830WARNINGWARNINGTo keep output drive balanced as it is being installed inthe vehicle, ensure sling assembly bracket is as close aspossible to open end of sling. Be careful when lifting out-put drive to ensure output drive clears the hull. To avoidfailure of sling or suitable lifting device, do not force suit-able lifting device to pull against weight of vehicle. Fail-ure to comply may cause damage to equipment or injuryto personnel.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
