TM 9--2350--292--20--20354 00--10OUTPUT REDUCTION UNIT (OUTPUT DRIVE) REPLACEMENT --CONTINUED0354 00Installation--Continued8. If not previously accomplished, attach lifting sling (item 25, WP 0717 00) to two lifting brackets (20) above trans-mission output housings (18). Attach lifting sling to suitable lifting device.9. At right output drive, verify that alignment half ring (31) is properly seated in single groove in lower saddle of out-put drive (19). If not, set alignment half ring (31) firmly in groove with ends flush with saddle flange.Figure 1662018193110. With suitable lifting device, raise rear of powerpack and remove hardwood blocks under transmission. Lowerpowerpack until transmission output housings (18) rest on saddles of output drives (19) with right drive alignmenthalf ring (not shown) in bottom of outer groove of right output housing.11. Pry output couplings (17) out of output drives (19) and into both transmission output housings (18) as far as pos-sible.12. Remove access plug (32) from left steer clutch housing (33).Figure 1661718193332
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
