TM 9--2350--292--20--20355 00--1BRAKE LINKAGE ALIGNMENT, ADJUSTMENT AND BLEEDING(OLD CONFIGURATION)0355 00THIS WORK PACKAGE COVERS:Alignment, Adjustment, BleedingINITIAL SETUP:Tools and Special ToolsGeneral mechanic’s tool kit (item 1, WP 0717 00)Torque wrench (item 2, WP 0717 00)Twist drill set (item 12, WP 0717 00)Materials/PartsCotter pins (4) (item 17, WP 0718 00)Safety goggles (item 93, WP 0716 00)Lubricant (item 51, WP 0716 00)Rope (item 34, WP 0716 00)Lubricant (item 87, WP 0716 00)Equipment ConditionsVehicle parked on level surface with tracks blockedand brakes released (TM 9--2350--292--10)Powerpack removed (WP 0188 00)For alignment onlySubfloor access plate #6 removed (WP 0454 00)For alignment onlyHull engine compartment access covers removed(WP 0434 00)For access to brake linkagesSubfloor access plate #16 opened (WP 0454 00)For bleeding onlyPersonnel RequiredTwoReferencesTM 9--2350--292--10WARNINGAdjustment to length of rod assemblies must be accom-plished by adjusting both end clevises or rod end bearingsevenly. Rod end clevises or rod end bearings must maintainspecified thread engagement length from end of rod assem-blies as a minimum at all times. Failure to comply could re-sult in rod assembly separation causing loss of vehicle ser-vice brake, resulting in personnel injury or equipmentdamage.NOTEIf an alignment is performed, an adjustment is also neces-sary. An adjustment alone can be performed, if required.Bleeding must be performed if any hydraulic lines or compo-nents are repaired or replaced.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
