Installation - TM-9-2350-292-20-2

AUXILIARY POWER UNIT FUEL/WATER SEPARATOR REPLACEMENT (HATZ)

AUXILIARY POWER UNIT FUEL SYSTEM LINES AND FITTINGS REPLACEMENT (HATZ)

TM-9-2350-292-20-2 Recovery Vehicle Heavy Full-Tracked: M88A2 (NSN 2350-01-390-4683) (EIC:ACQ) Manual
Page Navigation
951

TM 9--2350--292--20--2 0616 00--2 AUXILIARY POWER UNIT FUEL/WATER SEPARATOR REPLACEMENT (HATZ) -- CONTINUED 0616 00 Installation 1. Apply sealing compound to threads of fittings (3 and 13). 2. Install fitting (13) with hose (2) and clamp (12) to fuel/water separator (8). 3. Apply sealing compound to threads of elbow (11), hose (10) and quick--disconnect coupling half (9). 4. Install elbow (11) in inlet side #3 of fuel/water separator (8). 5. Install hose (10) on elbow (11) and install quick--disconnect coupling half (9) on hose (10). 6. Apply adhesive (item 29, WP 0716 00) to two screws (6). 7. Install fuel/water separator (8) with two screws (6) and two new lockwashers (7). 8. Install fitting (3) with hose (2) to upper fuel pump (5) and tighten clamp (1). 8 6 7 9 10 11 13 12 5 3 4 2 1 NOTE FOLLOW--ON MAINTENANCE: Install APU assembly (WP 0587 00) END OF TASK

Privacy Statement
Press Release
Contact