CHAPTER 9: MAINTENANCE OF HULL- AND CAB-RELATED COMPONENTS
TM 9-2350-256-20
9-31 REPLACE WIRE ROPE ROLLER ACCESS DOOR
THIS TASK COVERS
a.
Removal
b. Installation
INITIAL SET-UP
Material/Parts:
Adhesive (Appendix D, item 2)
Lockwashers (2) (Appendix G, item 138)
Pin, cotter (Appendix G, item 220)
Pins, spring (2) (Appendix G, item 231)
Seal (Appendix G, item 257)
a.
REMOVAL
1
Remove two nuts (1), two lockwashers (2), and two
flat washers (3).
2
Remove two eyebolts (4) by removing spring pin
(5) from each hull tab.
3
Remove wire rope roller access door (6) from hull
by removing cotter pin (7), flat washer (8), and
straight pin (9).
4
Remove rubber seal (10) from wire rope roller
access door (6).
b. INSTALLATION
1
Install new rubber seal (10) on wire rope roller
access door (6) with adhesive.
2
Install wire rope roller access door (6) with straight
pin (9), flat washer (8), and new cotter pin (7).
3
Install two eyebolts (4) and secure each to hull with new spring pin (5).
4
Secure wire rope roller access door (6) to hull with two flat washers (3), two new lockwashers (2), and two
nuts (1).
9-32 REPLACE LEFT AND RIGHT STOWAGE COMPARTMENT DOORS
THIS TASK COVERS
a.
Removal
b. Installation
INITIAL SET-UP
Tools:
Material/Parts:
Personnel Required:
Tool kit, general mechanic's
Adhesive (Appendix D, item 3)
Two
(Appendix C, item 53)
Pins, cotter (2) (Appendix G, item 213)
Riveter, blind (Appendix C,
Pins, cotter (4) (Appendix G, item 216)
item 42)
Rivets (4) (Appendix G, item 238)
Strip, rubber (Appendix G, item 274)
Strip, rubber (Appendix G, item 275)
9-54