TM 9-2350-238-10
Table 3-1. TROUBLESHOOTING–CONTINUED
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
14.
TRANSMISSION–CONTINUE
TRANSMISSION DOES NOT DRIVE IN ANY RANGE.
)
Step 1.
Check to see if transmission oil is low or over full.
Open transmission access door and check oil level. Oil level should
be within operating range stamped on dipstick (1). Add oil as re-
quired (appx G).
Step 2.
Remove deck transmission plate and inspect for damaged or broken control
linkage.
Refer to page 3-11. Notify unit maintenance personnel if linkage is
damaged.
DRIVING CONTROLS AND
15, VEHICLE DOES NOT STEER PROPERLY, OR PULLS
Step 1.
Check for unequal track tension.
Adjust track tension on both
LINKAGES
TO ONE SIDE.
tracks. Refer to page 3-45.
Step 2.
Check track for worn or missing track pads.
Notify unit maintenance personnel if track pads are worn or missing.
16. TRANSMISSION SHIFT DOES NOT ENGAGE TRANSMISSION PROPERLY.
Notify unit maintenance personnel.
17. BRAKES DO NOT HOLD VEHICLE ON GRADE.
Notify unit maintenance personnel.
Change 3
3-17
