TM 9-2350-256-20-1
0043 00
CORRECTIVE ACTION Continued
7.
Reconnect switch panel to neutral safety to bulkhead wiring harness at bulkhead disconnect. Discon-
nect wire 14 of bulkhead to engine wiring harness and starter relay wiring harness from connector
near bulkhead disconnect. Place red lead of multimeter on male connector and black lead to ground.
Turn MASTER switch on, push START switch, and check for voltage. Turn MASTER switch OFF. If
voltage is present, go to step 8. If voltage is not present, replace/repair wire 14 of bulkhead to engine
wiring harness and starter relay wiring harness (see WP 0221 00).
8.
Reconnect wire 14 of bulkhead to engine wiring harness and starter relay wiring harness to connector
near bulkhead disconnect. Remove engine deck (see WP 0336 00). Disconnect wire 14 of batteries to
master relay, voltage regulators, slave receptacle, and engine disconnect wiring harness from connector
near engine disconnect. Place red lead of multimeter on male connector of wire 14 and black lead to
ground. Turn MASTER switch on, push START switch and check for voltage. Turn MASTER switch
OFF. If voltage is not present, replace/repair wire 14 of bulkhead to engine disconnect wiring harness
(see WP 0222 00 for dual voltage; 0223 00 for single voltage). If voltage is present, go to step 9.
0043 00-7
