TM 9-2350-256-20-1
0043 00
CORRECTIVE ACTION Continued
9.
Reconnect wire 14 of engine disconnect wiring harness to connector near engine disconnect. Remove
engine deck (see WP 0336 00). Disconnect batteries to master relay, voltage regulators, slave recep-
tacle, and engine disconnect wiring harness from engine disconnect. Place red lead of multimeter in
socket C of wire 14 and black lead to ground. Turn MASTER switch on, push START switch, and
check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 10. If voltage is not
present, replace/repair wire 14 of batteries to master relay, voltage regulators, slave receptacle, and
engine disconnect wiring harness (see WP 0190 00 for dual voltage; 0191 00 for single voltage).
10. Remove powerplant and connect groundhop kit (see WP 0098 00 and 0099 00). Reconnect battery
to master relay, voltage regulators, slave receptacle, and engine disconnect wiring harness to engine
disconnect. Disconnect module starter wiring harness from low voltage protection module. Place red
lead of multimeter in socket A of wire 14 and black lead to ground. Turn MASTER switch on, push
START switch, and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step 11.
If voltage is not present, replace/repair wire 14 of module starter wiring harness (see WP 0189 00).
0043 00-8
