TM 9-2350-256-20-1
0052 00
CORRECTIVE ACTION Continued
4.
Disconnect gage panel to bulkhead wiring harness from gage panel. Check wire 324 in gage panel
harness for continuity by placing red lead of multimeter on wire 324 and black lead on pin B of wire
324. If continuity is present, go to step 5. If continuity is not present, repair/replace wire 324 of gage
panel wiring harness (see WP 0193 00).
5.
Reconnect wire 324 to transmission oil temperature gage and gage panel to bulkhead wiring harness
to gage panel. Install ground strap (5), two lockwashers (4), two screws (3), gage panel (6), three
lockwashers (2), and three screws (1) to mounting brackets. Open air inlet doors (TM 9-2350-256-10).
Disconnect bulkhead to engine bracket and rear fuel tank transmitter wiring harness from bulkhead
disconnect. Place red lead of multimeter in socket J of wire 324 and black lead to ground. Turn
MASTER switch on and check for voltage. Turn MASTER switch OFF. If voltage is present, go to step
6. If voltage is not present, repair/replace wire 324 of gage panel to bulkhead wiring harness (see WP
0194 00 for dual voltage; 0195 00 for single voltage).
0052 00-4
