TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
TYPICAL MALE-TYPE PANEL MOUNTING RECEPTACLE (WITH RIDGED LOCKING NUT) REPAIR
DISASSEMBLY, ASSEMBLY
INITIAL SETUP:
Tools and Special Tools
References
Tool kit, general mechanic's (item 59, WP 0490 00)
TB SIG 222
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and
burns.
Disassembly
1.
Unscrew nut (1) from shell assembly (2) and slide back on cable leads (3).
2.
Push grommet (4) back on cable leads (3).
3.
Drive pin contacts (5) out through rear of insert (6) with pin extractor.
4.
Unsolder cable leads (3) from pin contacts (5).
Assembly
1.
Strip cable leads (3) insulation equal to depth of solder wells of pin contacts (5).
2.
Slide nut (1) over cable lead (3).
3.
Slide grommet (4) over cable leads (3).
4.
Insert cable leads (3) into solder wells of pin contacts (5) and solder (use resin core solder only) (refer to TB SIG 222).
5.
Push insert (6) into shell (2) from rear until seated. Groove (7) in insert must be aligned with guide in shell (2) to ensure
proper fit.
6.
Push pin contacts (5) into insert (6) from rear until seated.
7.
Push grommet (4) down cable leads (3) and over solder wells of pin contacts (5).
8.
Screw nut (1) onto shell assembly (2).
END OF WORK PACKAGE
0262 00-1/2 blank
