TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
TYPICAL MALE-TYPE PANEL MOUNTING RECEPTACLE REPAIR
DISASSEMBLY, ASSEMBLY
INITIAL SETUP:
References
Tools and Special Tools
Tool kit, general mechanic's (item 59, WP 0490 00)
TB SIG 222
Materials/Parts
Rod (item 28, WP 0489 00)
WARNING
Be certain MASTER switch is OFF when working on electrical system to avoid electrical shock and
burns.
NOTE
In plug and receptacle assemblies, plug all spare grommet holes with rod.
Disassembly
1.
Drive pin contacts (1) out through rear of insert (2) with pin extractor.
2.
Unsolder cable leads (3) from solder wells on pin contacts (1).
3.
Slide insert (2) out through rear of shell (4).
Assembly
1.
Strip cable (3) insulation equal to depth of solder wells of pin contacts (1).
2.
Insert cable leads (3) into solder wells of pin contacts (1) and solder (use resin core solder only) (refer to TB SIG 222).
3.
Push insert (2) into shell (4) from rear until seated. Groove (5) in insert must be aligned with guide in shell (4) to ensure
proper fit.
4.
Push pin contacts (1) into insert (2) from rear until seated.
END OF WORK PACKAGE
0260 00-1/2 blank
