TM 9-2350-256-20-2
0314 00
6.
Remove adjusting screw (11) and self-locking nut (12) from control arm (6).
7.
Remove retaining latch (13) by removing cotter pin (14), straight pin (15), spring (16), and washer (17).
8.
Remove spring (18) from shaft housing (5).
9.
Remove retaining ring (19), bearing retainer (20), bearing (21), and disk (22).
Disassembly
1.
Remove retaining ring (23), two bearings (24), and packing (25) from shaft housing (5).
Assembly
1.
Install two bearings (24), retaining ring (23), and packing (25) in shaft housing (5) and lubricate (see WP 0097 00).
Installation
Install disk (22), bearing (21), and bearing retainer (20), and secure with retaining ring (19).
1.
Install spring (18) in shaft housing (5).
2.
Install retaining latch (13) with straight pin (15), spring (16), washer (17), and cotter pin (14).
3.
Install adjusting screw (11) and self-locking nut (12) on control arm (6).
4.
0314 00-3
