TM 9-2350-256-20-2
0315 00
Removal
1.
Raise rigger's cab-top door (1) about 2 in. (51 mm) to align self-locking nuts (2 and 3) on arm control pin (4) with opening
in shaft housing (5).
2.
Remove control arm (6) by removing self-locking nut (2), arm control pin (4), washer (7), and self-locking nut (3).
3.
Remove rigger's cab-top door (1) by pulling up through shaft housing (5).
4.
Remove access cover (8), gasket (9), and access cover (10) from inside rigger's cab-top door (1) by removing six screws
(11) and six lockwashers (12).
5.
Remove rubber strip (13) from rigger's cab-top door (1).
6.
Remove shaft housing (5) by removing five screws (14) and five lockwashers (15).
7.
Remove cushioning pad (16) from shaft housing (5).
0315 00-2
