TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
VISE MOUNTING HARDWARE AND ADAPTER PLATE REPLACEMENT
REMOVAL, INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Materials/Parts (cont.)
Tool kit, general mechanic's (item 59, WP 0490 00)
Screws (4) (item 417, WP 0491 00)
Materials/Parts
Screws (4) (item 803, WP 0491 00)
Lockwashers (8) (item 642, WP 0491 00)
Washers, flat (8) (item 539, WP 0491 00)
NOTE
The M88A1 uses either a three- or four-mounting-hole vise. The four-mounting-hole vise procedure is
shown.
Removal
1.
Remove vise (1) by removing four screws (2), four lockwashers (3), and four flat washers (4).
NOTE
Vise adapter plate is required only when three-mounting-hole vise is used. Proceed with step 2 only if
necessary.
2.
Remove vise adapter plate (5) by removing four screws (6), four lockwashers (7), and four flat washers (8).
0372 00-1
