CHAPTER 9: MAINTENANCE OF HULL-AND CAB-RELATED COMPONENTS `
TM 9-2350-256-20
9-76
REPLACE/REPAIR SHIFTING CONTROLS AND LINKAGES-Continued
27
Remove mounting bracket (78) by removing three
screws (91), three lockwashers (92), and flat washer
(93).
b.
DISASSEMBLY
1
Remove cotter pin (94), two straight pins (95), and
lever (96) from transmission shift control assembly
(8).
2
Remove knob (97), three bolts (98), three
lockwashers (99), three spacers (100), and mounting
bracket (101).
3
Remove straight pin (102) and lever (103).
4
Remove screw (104), lockwasher (105), lever (22), and key (106).
5
Remove straight pin (107), shaft (108), segment assembly (109), and bearing unit (110).
6
Remove setscrew (111), spring (112), and plunger (113).
7
Remove seal (114) and two bearings (115).
8
If necessary, remove two lubrication fittings (116) from base (117) and fitting (118) from bearing unit (110).
9-164
