T M 9 - 2 3 5 0 - 2 5 6 - 2 0
CHAPTER 9:
MAINTENANCE OF HULL- AND CAB-RELATED COMPONENTS
9-76 REPLACE/REPAIR SHIFTING CONTROLS AND LINKAGES-Continued
5
Remove circuit breaker (11) from transmission shift control assembly (8) by removing two nuts (12), three
lockwashers (13), and two screws (14).
6
Remove rod assembly (15) by removing straight pm (16) and cotter pm (17) from each end.
7
Remove clevis (18) and nut (19) from each end of
rod assembly (15).
8
Remove stud assembly (20) from levers (21 and 22)
by removing two screws (23) and two lockwashers
(24). Remove bearing (25) and nut (26) from each
end of stud assembly.
9
Remove transmission shift control assembly (8) and
shims (27) by removing four screws (28), four
lockwashers (29), two screws (30), two lockwashers
(31), and two flat washers (32).
10 Remove screw (33) and lockwasher (34).
11 Remove two levers (21 and 35) and two keys (36)
from shaft (37) by removing screw (38) and
lockwasher (39) from each lever.
9 - 1 6 0
