SERVICE ALIGNMENT OF STEERING CONTROLS AND LINKAGES

INSTALLATION (cont) - TM-9-2350-256-20_1034

REPLACE/REPAIR STEERING CONTROL ASSEMBLY

TM-9-2350-256-20 Carrier Cargo Tracked 6-Ton M548A1 (2350-01-096-9356) M548A3 2350-01-369-6081 Manual
Page Navigation
1022

CHAPTER 9: MAINTENANCE OF HULL- AND CAB-RELATED COMPONENTS TM 9-2350-256-20 9-73 SERVICE ALIGNMENT OF STEERING CONTROLS AND LINKAGES-Continued ALIGNMENT 1 Disconnect rear steering rod from transmission steer levers. Insert 1/8-in.- (3.2-mm-) diameter locating pins in steering control lever (point 1) and adjust upper steering control tube until steering control is in center (no- steer) position. 2 Insert locating pins in levers at points 2 through 5, adjusting lower steering control tube and linkage between points 2 and 5 as necessary to permit pinning. 3 Adjust rear steering rod until rod clevis hole aligns with hole in transmission steer lever with steering position indicator on transmission valve body pointing to center (no-steer) dot (point 6). Connect rod to lever. 4 Extend rubber bellows to 4-1/2 in. (114 mm). Cement rubber bellows to bulkhead with adhesive and clamp rubber bellows to rod. Tighten all nuts and remove locating pins. Connect rear steering rod to transmission steer levers. NOTE Follow-on maintenance: Install batteries (see paragraph 6-4) Install powerplant (see paragraph 3-1) 9-156

Privacy Statement
Press Release
Contact