CHAPTER 2: VEHICLE MAINTENANCE INSTRUCTIONS TM 9-2350-256-202-19 ELECTRICAL TROUBLESHOOTING-ContinuedGAGE PANEL LIGHTS-ContinuedWARNINGRemove all jewelry such as rings, dog tags,bracelets, etc. If jewelry contacts a metalsurface a direct short may result in instantheating of tools, damage to equipment, andinjury or death to personnel.E. Reconnect switch panel to gage panel andmiscellaneous switches wiring harness to main switchpanel. Install main switch panel (11), flat washer (10),ground lead (9), three lockwashers (8) and threescrews (7). Disconnect wire 40 of gage panel tobulkhead wiring harness from switch panel to gagepanel and miscellaneous switch wiring harness. Placered lead of multimeter on male connector of wire 40and black lead to ground Turn MASTER switch on andcheck for voltage. Turn MASTER switch OFF. Ifvoltage is present repair/replace wire 40 of gage panelto bulkhead wiring harness (see paragraph 6-45 fordual voltage; 6-46 for single voltage). If voltage isnot present, repair/replace wire 40 of switch panelgage panel and miscellaneous switches wiring harness(see paragraph 6-55 for dual voltage; 6-56 for singlevoltage).F Place red lead of multimeter on pin N of wire10/15 and black lead to ground. Turn MASTER switchon and check for voltage. Turn MASTER switch OFF.If voltage is present, go to step G. If voltage is notpresent, go to step K.2-270
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business