SECTION I: ENGINE COOLING FANSTM 9-2350-256-204Check clearance between tip of each fan blade andrim of cooling fan housing (9) with feeler gage. Ifclearance is less than 0.062 inch (in.) (1.58millimeters [mm] ) at any point, loosen cooling fanhousing mounting screws (10) and shift cooling fanhousing to gain clearance.5Using torque wrench, check release torque ofcooling fan clutch. If clutch does not release atapproximately 20 lb-ft (27 N•m), notify DirectSupport Maintenance.6Position housing (1) on cooling fan housing (9) andinstall four screws (2) and four new lockwashers(3).NOTEFollow-on maintenance:Install shroud seals(see paragraph 5-1)5— 3 REPLACE/REPAIR ENGINE COOLING FAN HOUSINGSTHIS TASK COVERSa. Removalb. Disassemblyc. Assemblyd. InstallationINITIAL SET-UPTools:Parts-Continued:Equipment Condition:Tool kit, general mechanic's·Inserts (8) (Appendix G, itemCooling fans removed (see(Appendix C, item 53)89)paragraph 5-2)·Lockwashers (8) (Appendix G,Parts:item 96)·Inserts (8) (Appendix G,·Nuts, self-locking (2)item 88)(Appendix G, item 167)a.REMOVAL1Remove 2 access covers (1) by removing 10 screw(2).2Remove two screws (3), two flat washers (4), antwo self-locking nuts (5).5—3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
