CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6 1 REPLACE/REPAIR ENGINE GENERATOR, CRADLE, SUPPORT, AND RELATED PART S--Continued
3
Install generator exhaust boot (31).
4
Place generator (32) into generator exhaust boot
(31) and turn clockwise until generator is locked in
place.
5
Assemble bracket (40) to generator cradle (39)
using new self-locking nut (41) and flat washer
(42).
6
Install generator cradle (39) using four screws (37)
and four flat washers (38). Secure screws using
new lockwire (36).
7
Install ground strap (28) using new self-locking nut
(34) and flat washer (35).
8
Install six nuts (33) using wrench and slide
generator exhaust boot (31) into place.
9
Connect two leads (27) and ground strap (28) on generator (32) using nut (29) and flat washer (30) for each.
10 Install U-bolt (24) using two new self-locking nuts (25) and two clamping bars (26).
11 Install four clamps (23).
12 Install clamp (22).
6
6